2023-04-12

Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)

Correction code 17102102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH rear EPB harness bracket to the LH rear caliper
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • 4 in extension
Reuse
Bolt that attaches the LH rear EBP harness bracket to the body
5 Nm (3.7 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  3. Remove the LH rear wheel liner. See Wheel Arch Liner - Rear - LH (Non-Structural Pack) (Remove and Replace).
  4. Release the connector lock, and then disconnect the LH electronic parking brake caliper electrical connector.
  5. Remove the bolt that attaches the LH rear EPB harness bracket to the LH rear caliper.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
  6. Remove the bolt that attaches the LH rear EPB harness bracket to the body.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Release the clip that attaches the LH rear EPB harness to the bracket body.
  8. Release the clip that attaches LH rear EPB harness to the body.
  9. Release the connector lock, and then disconnect the LH rear electronic parking brake harness from the rear main body harness.

Install

Installation procedure is the reverse of removal.