2022-06-20
Noise Absorber - Motor Bay - Rear (Remove and Replace)
Correction code
12010202 2.70
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the rear subframe. See Subframe Assembly - Rear (Remove and Install).
- Remove the clips (x6) that attach the rear motor bay noise absorber to the body, and then remove the noise absorber from the vehicle.
Install
Installation procedure is the reverse of removal.