Hose - Passthrough - Front Manifold - HV Battery (Male Coupler) (Retrofit)
Correction code
18309906
FRT 0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
- Position front manifold coolant hose onto HV battery
-
Install front hose assembly onto HV battery and secure RH outer coolant hose connection
Note1x spring clip, Perform push-pull-push test to make sure hose is fully seated
-
Connect RH inner coolant hose to front of HV battery
Note1x spring clip, Perform push-pull-push test to make sure hose is fully seated
-
Connect LH inner coolant hose to front of HV battery
Note1x spring clip, Perform push-pull-push test to make sure hose is fully seated
-
Connect LH outer coolant hose to front of HV battery
Note1x spring clip, Perform push-pull-push test to make sure hose is fully seated
-
Remove plug then connect HV battery front manifold coolant hose
Note1x spring clip, 1x plugs, Perform push-pull-push test to make sure hose is fully seated, Loss of coolant greater than 1L requires coolant vacuum fill