20/07/2023 02:02:48

Sun Visor - LH (Remove and Replace)

Correction code 15051002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

    Torque Specifications

    Table 1. Torque Specifications: Sun Visor - LH (Remove and Replace)
    Description Torque Value Recommended Tools Reuse/Replace Notes
    Bolt that attaches the sun visor to the vehicle
    3.5 Nm (2.6 lbs-ft)
    • Torx T25 socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 2 in extension
    		Reuse

    Remove

    1. Release the clips (x4) that attach the sun visor bracket cover to the vehicle.
    2. Remove the fastener that attaches the sun visor to the vehicle.
      3.5 Nm (2.6 lbs-ft)
      Tip: Use of the following tool(s) is recommended:
      • Torx T25 socket
      • ¼ in std ratchet
      • ¼ in torque wrench (installation only)
      • 2 in extension
    3. Disconnect the electrical connector from the sun visor.
    4. Remove the sun visor from the vehicle.

    Install

    Installation procedure is the reverse of removal.