19/02/2021 13:38:59

Bolster - Seat Cushion - 3rd Row - LH (Remove and Replace)

Correction code 13060012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all the doors and fully lower all the windows.
  2. Move the front seats fully forward.
  3. Move the 2nd row seats into easy entry mode.
  4. Remove the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).
  5. Remove the bolt that attaches the 3rd row LH seat cushion bolster to the vehicle, and then slide the bolster forward to remove it from the assembly.
    37 Nm (27.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Position the 3rd row LH seat cushion bolster into the vehicle, and then install the bolt.
    37 Nm (27.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
    • Flex head ratchet/flex head torque wrench
  2. Install the 3rd row seat cushion. See Cushion - Seat - 3rd Row (Remove and Replace).
  3. Move the 2nd row seats and front seat into the original positions.
  4. Raise all the windows and close all the doors.