23/11/2022 13:52:55

Power Socket 12V - Rear Trunk (Remove and Replace)

Correction code 17303202 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. N/A

Remove

  1. Open the liftgate.
  2. Open the LH front door.
  3. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  4. Release the clips (x4) that attach the top edge of the LH trunk side trim to the vehicle, and then carefully pull back the top edge of the trim.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool
  5. Disconnect the rear trunk power socket 12V connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid pulling the connector wiring. Press and pull to release the connector.
  6. Release the rear trunk power socket 12V connector from the LH trunk side trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the connector upwards until it clears the mounting tab.
  7. Gently push the rear trunk power socket 12V forward, while simultaneously pulling the upper and lower mount tabs outward to release the power socket 12V from the LH trunk side trim, and then remove the power socket 12V from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Pick Miniature Soft Grip, 90 degree tip, 6 in

Install

  1. Position the rear trunk power socket 12V on the vehicle, insert the connector first, followed by the mount, and then the power socket 12V outlet. Gently push the outlet with the cover facing upwards to secure in place.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure proper fitment of the power socket 12V.
  2. Install the rear trunk power socket 12V connector on the LH trunk side trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the connector downwards until fully lowered on the mounting tab.
  3. Connect the rear trunk power socket 12V connector.
  4. Install the clips (x4) that attach the top edge of the LH trunk side trim to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace clips as necessary. Attach the clip closest to rear seat back first, and then work towards the liftgate.
  5. Connect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  6. Close the liftgate.
  7. Close the LH front door.