13/07/2023 09:33:05

Foam - Cushion - Front Passenger Seat (Remove and Replace)

Correction code 13070202 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the front passenger seat seat cushion trim. See Trim - Cushion - Front Passenger Seat (Remove and Replace).
  2. While wearing cut-resistant gloves, carefully use a razor blade to separate the resistive occupancy sensor from the passenger seat cushion foam.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Always wear cut-resistant gloves when using cutting tools.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage the sensor harness, seat trim, or other surrounding components with the razor blade.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care to remove as little foam as possible.
  3. Position the resistive occupancy sensor on top of the passenger seat cushion foam, and then route the sensor harness through the harness opening in the foam.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    While installing the harness, take care not to damage the foam.
    Figure 1. Resistive occupancy sensor positioned on top of the front seat cushion foam
    Figure 2. Resistive occupancy sensor harness routed through the bottom of the front seat cushion foam

Install

  1. Position the resistive occupancy sensor on top of the passenger seat cushion foam, and then route the sensor harness through the harness opening in the foam.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    While installing the harness, take care not to damage the foam.
    Figure 3. Resistive occupancy sensor positioned on top of the front seat cushion foam
    Figure 4. Resistive occupancy sensor harness routed through the bottom of the front seat cushion foam
  2. Install the front passenger seat seat cushion trim. See Trim - Cushion - Front Passenger Seat (Remove and Replace).