25/11/2024 18:53:20
Buckle - 1st Row - LH (Remove and Replace)
Correction code 20054702 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-11-26: Add a note to ensure the engage the pin on the buckle with the slot in the seat track.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Patchbolt that attaches the buckle to the seat track |
|
|
Replace | 1117250-00-A |
Remove
- Remove the inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Disconnect the electrical connector from the LH 1st row buckle.
- Release the harness clip from the seat bottom frame.
-
Remove and discard the
patchbolt that attaches the buckle to the seat track, and then remove the
buckle.
Tip: Use of the following tool(s) is recommended:
- Torx T50 socket
- 3/8 in std ratchet
- 3/8 in torque wrench (installation only)
- 3 in extension
Install
-
Install the patchbolt that
comes with the new seat belt buckle to attach the buckle to the seat
track.NoteMaking sure to engage the pin on the buckle with the slot in the seat track.Tip: Use of the following tool(s) is recommended:
- Torx T50 socket
- 3/8 in std ratchet
- 3/8 in torque wrench (installation only)
- 3 in extension
- Connect the electrical connector from the LH 1st row buckle.
- Connect 12V power. See 12V/LV Power (Disconnect and Connect).
- Raise the seat to its highest position while inspecting the seat belt buckle harness with a flashlight to make sure its not catching on anything.
- Make sure the seat belt buckle harness is routed in front of the datum and not around the datum.
- With the seat still at its highest position, adjust and secure the seat belt buckle harness clip along the inner seat rail and verify the harness is extended as far forward as possible to eliminate slack on the back side of the clip.
- Fully raise and lower the seat, inspecting the seat belt buckle harness with a flashlight to make sure its not catching on anything.
- Install the inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).