14/09/2023 04:03:50

Wiper Arm - RH (Remove and Replace)

Correction code 17500352 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1058696-00-A Wiper Arm Removal Tool

Torque Specifications

Table 1. Torque Specifications: Wiper Arm - RH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the RH wiper arm to the wiper motor assembly
25 Nm (18.4 lbs-ft)
  • 15 mm socket
  • 3/8 in std ratchet
  • 3/8 in torque wrench (installation only)
Reuse

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the RH wiper arm nut cover.
  3. Disconnect the RH wiper arm hose from the Y-tube, and then release the hose from the clip.
  4. Remove the nut that attaches the RH wiper arm to the wiper motor assembly.
    25 Nm (18.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
  5. Place the base of the wiper arm removal tool under the RH wiper arm and position the set screw so that it is centered and touching the wiper arm stud, and then tighten the set screw until the wiper arm is released.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Removing the wiper arm without the wiper arm removal tool may result in damage to the wiper arm or wiper motor.
  6. Remove the RH wiper arm and hose assembly from the vehicle.

Install

  1. Position the RH wiper arm onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the RH wiper tip is aligned between the two indicators at the corner of the windshield.
  2. Install the nut that attaches the RH wiper arm to the wiper motor assembly.
    25 Nm (18.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
  3. Connect the RH wiper arm hose to the Y-tube, and then install the hose into the clip.
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).