2023-12-15
Support Hinge - Controller - High Voltage (Remove and Replace)
Correction code
163016121.44
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the high voltage controller tray from ancillary bay. See Controller - High Voltage (Non-Structural Pack) (Remove and Replace).
- Remove the HV controller support hinge from the HVC and hinge tray .
Install
- Install the HV controller support hinge from the HVC and hinge tray .
- Install the high voltage controller tray to ancillary bay. See Controller - High Voltage (Non-Structural Pack) (Remove and Replace).