26/11/2021 05:44:38

Siren - Battery Backed (Remove and Replace)

Correction code 17451002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Siren - Battery Backed (Remove and Replace)

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Remove the bolt that attaches the battery backed siren bracket to the vehicle.
    8 Nm (5.9 lbs-ft)
  3. Remove the battery backed siren from the bracket.
  4. Disconnect the battery backed siren connector, and then remove the battery backed siren from the vehicle.

Install

Installation procedure is the reverse of removal.