2025-04-07

NVH Tape - Brake Pads - Front (EMEA) (Retrofit)

Correction code 33010706 0.20

  • 2025-03-03: Updated notes.
  • 2024-07-15: Updated procedure for pre-cut stickers and added region information.
  • 2024-06-25: Updated notes.
  • 1994754-00-A STICKER FOR CALIPER

Procedure

Informational PurposesAn informational icon, calling your attention
Note
This is an additional procedure, to prevent NVH issues. This procedure is only applicable to the EMEA market.
Informational PurposesAn informational icon, calling your attention
Note
Add this correction code as an extra activity to the service visit, combined with the correction code for Brake Pads (Remove and Install or Remove and Replace).
  1. Clean the back side of the front brake pads (x4) and the surfaces of the brake caliper pistons (x8) using brake cleaner.
  2. Align the pre-cut NVH sticker to the back side of the front brake pads (x4), and then apply pressure on the stickers to adhere them to the brake pads.
  3. Remove the protective cover from the NVH sticker applied to the brake pads (x4).
  4. Clean the brake caliper retaining pins (x4) using a hand brush and soapy water, and then apply an even layer of Silaramic lubricant to the brake caliper retaining pins.
  5. Proceed with the installation of the front brake pads.