04/09/2024 15:20:00

Speaker - Pedestrian Warning (Remove and Replace)

Correction code 17541002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. Remove the RH front wheel. See Wheel Assembly (Remove and Install).
  2. Remove the RH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  3. Remove the clips (x8) that attach the front portion of the RH front wheel arch liners to the vehicle, and then move the wheel arch liner aside to perform the following steps.
  4. Release the clip that attaches the electrical harness to the pedestrian warning speaker assembly.
  5. Slide the locking tab away from the connector, and then press down on the locking tab to disconnect the connector from the pedestrian warning speaker assembly.
  6. Remove the screws that attach the pedestrian warning speaker assembly to the front fascia, and then remove the speaker from the fascia.
    1.8 Nm (1.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx Plus IP25 socket
    • Flex head ratchet / flex head torque wrench
    • 2 in extension

Install

Installation procedure is the reverse of removal.