2021-06-25

Air Extractor - LH (Remove and Replace)

Correction code 18105302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all the doors and liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Latch the rear doors to prevent accidental closing when vehicle is powered down.
  2. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  6. Remove the LH load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  7. Remove the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  8. Release the clips that attach the LH air extractor to the vehicle.
  9. Push the LH air extractor into the body panel, and then rotate outward to remove it from the vehicle.

Install

  1. Insert the LH air extractor into the body panel, rotate the extractor into position, and then pull the extractor outwards to the fasten the clips.
  2. Install the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  3. Install the LH load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  4. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  5. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  6. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  8. Close all the doors and liftgate.