Diffuser - Rear Fascia (Remove and Replace)
Correction code
12030802
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts that attach the rear fascia diffuser to the vehicle |
![]() 4 Nm (2.9 lbs-ft) |
|
Reuse |
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
-
Remove the bolts that attach the rear fascia diffuser to the vehicle.4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
- 2 in extension
- Remove the clips that attach the rear fascia diffuser to the body, and then remove the diffuser.
Install
Installation procedure is the reverse of removal.