Closeout Panel - Door - Rear - LH (Remove and Install)
Correction code 11701401 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts that attach the window regulator assembly to the door |
|
|
Reuse | |
Screws that attach the rear window regulator to the closeout panel |
|
|
Reuse |
Remove
- Remove the rear LH door glass. See Glass - Door - LH - Rear (Remove and Replace).
- Remove the LH rear door outer belt seal. See Seal - Outer Belt - Rear Door - LH (Remove and Replace).
- Release the connector lock, and then disconnect the LH rear window regulator motor connector.
- Remove the manual latch release cable from the window regulator panel.
- Release the connector lock, disconnect the electrical harness from the LH rear door pressure sensor connector, and then remove the pressure sensor from the LH rear window motor/regulator assembly.
- Release the clips that attach the door harness to the closeout panel.
-
Remove the bolts that attach
the window regulator assembly to the door.Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- 2 in extension
- Remove the plugs that cover the regulator rail fasteners.
-
Remove the bolts that attach
the closeout panel assembly to the door, and then slide the assembly down
and out to remove it from the door.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 6 in extension
Install
Installation procedure is the reverse of removal.