Shield - Dust - Brake - Front - LH (RWD) (Remove and Replace)
Correction code
33011602
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| LH front brake dust shield to the knuckle |
 8 Nm (5.9 lbs-ft) |
|
Reuse |
Remove
- Remove the LH front brake rotor. See Brake Rotor - Front - LH (Remove and Replace).
- Remove the LH front hub. See Hub - Front - LH (RWD) (Remove and Replace).
-
Remove the bolts that attach
the LH front brake dust shield to the knuckle, and then remove the dust
shield from the vehicle.8 Nm (5.9 lbs-ft)Tip: Use of the following tool(s) is recommended:
- T30 socket
- 4 in extension
Install
Installation procedure is the reverse of removal.