Finisher - Vent (Remove and Replace)
Correction code 14057502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2023-05-03: Added note for newer production vehicles screw count.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screws that attach the vent finisher to the IP carrier |
|
|
Reuse |
Remove
- Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
- Remove both the LH and RH air wave end caps. See End Cap - Air Wave - LH (Remove and Replace).
- Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
-
Remove the screws that
attach the LH side of the vent finisher.NoteNewer production vehicles may only have 4 screws.
-
Remove the screws that
attach the RH side of the vent finisher.NoteNewer production vehicles may only have 4 screws.
-
Release the clips (x16) that
attach the vent finisher, and then pull the finisher toward the rear of the
vehicle to remove it.
NoteThe top pad must be lifted slightly in order to insert a trim tool, and then release the clips.
Install
Installation procedure is the reverse of removal.