05/07/2022 16:08:02

Sensor - Cabin Temperature (Remove and Replace)

Correction code 18107502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Insert a plastic trim tool into the top center slot of the service panel, and then release the clips and tabs that attach the service panel to the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    An electrical harness is still connected to the service panel. Do not pull the service panel too far from the instrument panel.
  4. Disconnect the electrical harness from the cabin temperature sensor.
  5. Remove the service panel from the touchscreen.
  6. Remove the bolts that attach the cabin temperature sensor to the touchscreen, and then remove the sensor.
    0.7 Nm (6 lbs-in)

Install

Installation procedure is the reverse of removal.