Bracket - Trunk Pocket - LH (Remove and Replace)
Correction code
15306102
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure wearing proper PPE
when performing the below procedure. See Ergonomic Precautions for safe and healthy working
practices.
Remove
- Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
- Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
- Remove the trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
-
Release the push clip and alignment tabs (x5) that attach the LH trunk pocket bracket to the vehicle, and then remove the bracket from the vehicle.
Install
Installation procedure is the reverse of removal.