2024-09-04

Horn Assembly (Remove and Replace)

Correction code 17531202 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Torque Specifications

Table 1. Torque Specifications: Horn Assembly (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the horn assembly to the front subframe
12 Nm (8.8 lbs-ft)
  • 10 mm socket
  • 6 in extension
 Reuse

Remove

  1. Turn the steering wheel fully to the left.
  2. Remove the front LH fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  3. Remove the clips (x8) that attach the front LH wheel arch liner to the vehicle, and then pull the wheel arch liner towards the rear of the vehicle and out of the working area.
  4. Remove the bolt that attaches the horn assembly to the front subframe.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 6 in extension
  5. Disconnect the electrical connectors (x2) from the horn assembly.
  6. Remove the horn assembly from the vehicle.

Install

  1. Position the horn assembly for installation, and then connect the electrical connectors (x2) to the horn assembly.
  2. Install the bolt that attaches the horn assembly to the front subframe.
    12 Nm (8.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 6 in extension
  3. Install the clips (x8) that attach the front portion of the LH front wheel arch liner to the vehicle.
  4. Install the front LH fender garnish. See Garnish - Fender - Front - LH (Remove and Replace).
  5. Center the steering wheel.