18/08/2022 23:58:23

Hinge - Door - Front - Lower - LH (Remove and Replace)

Correction code 11336602 0.18NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1588903-00-A Body Gap and Flush Tool
  • 1079485-00-A Crowfoot Open End Set

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Use a jack to support the LH front door from the bottom.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to use soft material to protect the door paint.
  4. Apply masking tape to the area surrounding the LH front door lower hinge on the body and door to aid in alignment during installation.
  5. Remove the bolts (x2) that attach the LH front door lower hinge to the body.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  6. Remove the bolt that attaches the LH front door lower hinge to the door.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  7. Carefully remove the LH front door lower hinge from the vehicle.

Install

  1. Install the new LH front lower hinge.
  2. Hand-tighten the bolt that attaches the LH front door lower hinge to the door.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  3. Hand-tighten the bolts (x2) that attach the LH front door lower hinge to the body.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  4. Close the LH front door and check for gap and flushness. Adjust as necessary.
  5. Tighten the bolt that attaches the LH front door lower hinge to the door.
    49 Nm (36.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
  6. Tighten the bolts (x2) that attach the LH front door lower hinge to the body.
    24 Nm (17.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
  7. Remove the masking tape that surrounds the LH front door lower hinge on the body and door.
  8. Remove the support from the LH front door.
  9. Apply touch up paint to the LH front lower door hinge bolts as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to shake touch up paint before applying, and wait at least 20 minutes to allow the 1st coat to completely dry before applying the 2nd coat (if necessary).
  10. Raise the LH front window.
  11. Close the LH front door.