2026-08-09

Mirror - Rear View (Remove and Replace)

Correction code 15050202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-03-07: Added a note to clarify that the appearance of rear mirror mount may vary on newer vehicles, and some rear view mirrors are not secured by fasteners.
  • 2024-08-01: Added steps for AP4 vehicles.
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Torque Specifications

Table 1. Torque Specifications: Mirror - Rear View (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Rear view mirror to windshield mount bolt
2.5 Nm (1.8 lbs-ft)
  • Torx T20 bit
Replace 1090553-00-B

Remove

  1. Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
  2. For AP3 Vehicles: Remove and discard the bolt that attaches the rear view mirror to the windshield mount, and then carefully release the mirror from the windshield.
    CAUTION
    Do not yet completely remove the mirror, as an electrical harness is still attached.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  3. For AP4 Vehicles: Grip the rear view mirror stalk, and then turn counterclockwise to release the rear view mirror.
    CAUTION
    Do not turn the rear view mirror itself.
    CAUTION
    Do not yet completely remove the mirror, as an electrical harness is still attached.
  4. Disconnect the electrical connector from the rear view mirror, and then remove the mirror from the vehicle.

Install

  1. Connect the electrical connector to the rear view mirror.
  2. For AP3 Vehicles: Install a new bolt that attaches the rear view mirror to the windshield mount.
    2.5 Nm (1.8 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  3. For AP4 Vehicles: Grip the rear view mirror stalk, and then turn clockwise to install the rear view mirror.
    CAUTION
    Do not turn the rear view mirror itself.
  4. Install the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).