04/01/2024 04:42:14
Panel - Aero Shield - Mid (Remove and Replace)
Correction code 12030502 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-01-04: Updated consumables information.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the mid aero shield panel to the vehicle |
|
|
Reuse |
Note Apply threadlocker
to the threads of each bolt prior to installation. |
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove the push clips (x2) located at the LH and RH of the wheel house liner.
- Remove the bolts (x9) that attach the mid aero shield panel to the vehicle, and then remove the panel from the vehicle.
Install
- Apply a thin bead of threadlocker to the threads of the bolts that attach the mid aero shield panel to the vehicle.
-
Install the mid aero shield panel to the underside of the vehicle, and then install the bolts that attach the panel to the vehicle.
- Install the push clips (x2) located at the LH and RH of the wheel house liner.
- Lower the vehicle. See Raise Vehicle - 2 Post Lift.