Decor Trim - Instrument Panel - Main (Remove and Replace) (RHD)
Correction code 14054902 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
- Remove the LH air wave end cap. See End Cap - Air Wave - LH (Remove and Replace).
- Repeat steps 1 and 2 for the RH side of the vehicle.
- Release the clips (x14) that attach the main instrument panel decor trim, and then remove the trim from the instrument panel.
Install
Installation procedure is the reverse of removal, except for the following:
- Check for any damaged clips and replace them as necessary.
- Make sure that the instrument panel decor trim clips are fully seated to the instrument panel.
- Use Toolbox to perform an air wave functionality check to make sure the instrument panel decor trim clips are fully seated.