15/12/2022 01:49:46

Hinge - Door - Front - Upper - LH (Remove and Replace)

Correction code 11336402 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door and lower the window.
  2. Use a jack to support the LH front door from the bottom.
  3. Apply masking tape to the area surrounding the LH front door upper hinge on the body and door to aid in alignment during installation.
  4. Remove the bolts (x2) that attach the LH front upper door hinge to the body.
    24 Nm (17.7 lbs-ft)
  5. Remove the fastener that attaches the LH front upper door hinge to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    The fastener can either be a bolt (13 mm, torque 51 Nm) or a nut (13 mm, torque 28 Nm).
  6. Carefully remove the LH front upper door hinge from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Apply touch up paint on the LH front door hinge bolts as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Shake the touch up paint before applying. Allow the first coat to dry for 20 minutes before applying a second coat.