15/03/2023 05:46:28

Window Regulator Motor - Rear - LH (Remove and Replace)

Correction code 11505302 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Torque Specifications

Table 1. Torque Specifications: Window Regulator Motor - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the window motor to the closeout panel
3.5 Nm (2.6 lbs-ft)
  • Torx T25 socket
  • 2 in extension
Reuse

Remove

  1. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  2. Release the connector lock, and then disconnect the LH rear window regulator motor connector.
  3. Remove the screws that attach the LH rear window motor to the closeout panel, and then remove the motor from the panel.
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 2 in extension

Install

  1. Position the LH rear window regulator motor onto the closeout panel, and then install the screws that attach the window motor to the closeout panel.
    3.5 Nm (2.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 2 in extension
  2. Connect the LH window motor electrical connector, and then engage the connector lock.
  3. Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  4. Recalibrate the LH rear window regulator. See Window Regulator (Recalibrate).