05/06/2024 19:50:14

Tie Rod End - LH (Remove and Replace)

Correction code 32010302 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Tie Rod End - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the tie rod to the knuckle
180 Nm (132.7 lbs-ft)
  • 22 mm socket
  • 10 mm 12pt combination wrench
Replace 1109263-00-B
Jamb nut at the LH tie rod end
80 Nm (59.0 lbs-ft)
  • 21 mm 12pt combination wrench
  • 14 mm 12pt combination wrench
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Use a paint pen to apply a witness mark to the tie rod and jamb nut so that the two can be realigned later on during the LH tie rod end installation.
  4. Loosen the jamb nut at the LH tie rod end.
    Tip: Use of the following tool(s) is recommended:
    • 21 mm 12pt combination wrench
    • 14 mm 12pt combination wrench
  5. Remove and discard the nut that attaches the tie rod to the knuckle.
    Tip: Use of the following tool(s) is recommended:
    • 22 mm socket
    • 10 mm 12pt combination wrench
  6. Remove the LH tie rod end from the knuckle using a rubber hammer.
  7. Remove the tie rod from the steering linkage by turning the tie rod counter-clockwise.
    Informational PurposesAn informational icon, calling your attention
    Note
    Record the number of rotations for separation of the tie rod from the steering linkage.

Install

  1. Install the tie rod end to the steering linkage by turning the tie rod end clockwise using the exact number of turns recorded during removal.
  2. Install the new nut that attaches the tie rod end to the knuckle.
    180 Nm (132.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 22 mm socket
    • 10 mm 12pt combination wrench
  3. Use the witness marks to align the tie rod to the jamb nut and tighten the nut to secure the tie rod end in position.
    80 Nm (59.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 21 mm 12pt combination wrench
  4. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  5. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.