2025-03-03

Harness - USB - Car Computer to Glove Box (12V) (Remove and Replace)

Correction code 17106812 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Remove

  1. Remove the glove box. See Glove Box - Without Knee Airbags (Remove and Replace).
  2. Slowly peel the NVH pad near the USB harness clips.
  3. Release the clips (x2) that attach the USB harness to the glove box.
  4. Remove the screws (x2) that attach the USB harness to the glove box, and then remove the harness from the glove box.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:

Install

  1. Install the screws (x2) that attach the USB harness to the glove box.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
  2. Install the clips (x2) that attach the USB harness to the glove box.
  3. Move the NVH pad back to its original position.
  4. Install the glove box. See Glove Box - Without Knee Airbags (Remove and Replace).