2020-05-07

Bracket - Taillight - LH (Remove and Replace)

Correction code 10017102 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Taillight - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the LH taillight bracket to the vehicle
4 Nm (2.9 lbs-ft)
  • 10 mm socket
  • 4 in extension
Reuse

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Remove the bolts that attach the LH taillight bracket to the body, and then remove the bracket from the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension

Install

Installation procedure is the reverse of removal.