24/07/2020 09:48:49

SD Card - Car Computer (Remove and Replace)

Correction code 21152402 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH front door and fully lower the RH front window.
  2. Move the RH front seat fully rearward.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  5. Remove the RH footwell assembly. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  6. Use a trim tool to slide the SD card retaining tab over, and then use plastic tweezers to remove the SD card from the computer.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure not to remove the SIM card, located to the left of the SD card in this illustration.
  7. Destroy the SD card by cutting the card in half through the center, and then cut each piece into half, resulting in 4 pieces.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    It is mandatory to destroy the SD card to protect user data.

Install

  1. Position the SD card into the install guide.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the install guide slide is in the down position. Slide the SD card into the top of the tool from left to right until fully seated. The SD card contacts should be facing rearward during installation.
  2. Install the SD card into the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the guide locking tab upward until there is an audible click.
  3. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  5. Install the RH footwell assembly. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  6. Move the RH front seat to its original position.