09/12/2022 00:21:13

Recliner Actuator - Seat Back - 2nd Row - LH (Remove and Replace)

Correction code 13053302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Recliner Actuator - Seat Back - 2nd Row - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the 2nd row center/20 lumbar bun to the 2nd row seat
1.5 Nm (1.1 lbs-ft)
  • Torx T20 socket
Reuse
Screws that attach the LH 2nd row seat back recliner actuator from the actuator pan
2.5 Nm (1.8 lbs-ft)
  • 8 mm deep socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Open all four doors and fully lower all windows.
  2. Move the front seats fully forward.
  3. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Partially remove the LH rear door seal.
  5. Remove the LH rear sill trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  6. Remove the fasteners securing the 60 seat frame to body.
    Informational PurposesAn informational icon, calling your attention
    Note
    5x bolts, 11mm, 37 Nm, Bottom seat bolts located behind main carpet.
  7. Fold down the 60 seatback assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not place any additional weight on the seatback. Doing so may damage the seat frame alignment tabs, which can cause unevenness between the 60 and 40 seatbacks.
  8. Remove the LH 2nd row seatback panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).
  9. Remove the 2nd row 60 seat assembly from vehicle and leave the seat folded down.
    Informational PurposesAn informational icon, calling your attention
    Note
    Recommend assistance. Do not fold the seat up.
  10. Hold the 60 seat partially upwards with a hood prop but do not engage the seat lock.
  11. Release the clip and remove the center 2nd row inner B-cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    1x push clip, If you need extra access then fold the seat up but do not lock seat in the upward position.
  12. Release the actuator cable from the 60 seat frame clip, and then lift the cable up and away from the seat frame latch to separate it.
  13. Release the 60 seat recliner actuator connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  14. Remove the screws (x2) that attach the 60 seat back recliner actuator from the actuator pan.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm deep socket
    • Flex head ratchet/flex head torque wrench

Install

Installation procedure is the reverse of removal.