08/05/2020 11:11:57

Check Strap - Door - Front - LH (Remove and Replace)

Correction code 10106052 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1454796-00-A TOOLKIT, WINDOW SWITCH

Torque Specifications

Table 1. Torque Specifications: Check Strap - Door - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the check strap to the A-pillar
24 Nm (17.7 lbs-ft)
  • Torx T40 socket
  • Flex head ratchet/flex head torque wrench
Reuse
Nuts that attach the check strap to the door
10 Nm (7.4 lbs-ft)
  • 10 mm socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Remove the front LH door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  2. Temporarily connect the puddle lamp to the LH front door harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Route the electrical cable so that it will not be damaged when closing the door.
  3. Connect the window switch special tool.
  4. Latch the LH front door to fully raise the window.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not close the door with the window fully raised, as upper bright trim will be damaged.
  5. Raise the LH front window fully by accessing the window switch tool through the LH rear door.
  6. Remove the front door speaker. See Speaker - Front Door - LH (Remove and Replace).
  7. Remove the bolt that attaches the LH front door check strap to the A-pillar.
    24 Nm (17.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T40 socket
    • Flex head ratchet/flex head torque wrench
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Unbolting the door check allows the door to swing freely beyond opening limits.
  8. Remove the nuts (x2) that attach the check strap to the door.
    10 Nm (7.4 lbs-ft)
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
  9. Remove the check strap from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following: