01/07/2020 09:10:07

Bracket - Fascia Center To Fender - LH (Remove and Replace)

Correction code 10018102 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Fascia Center To Fender - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the headlamp to the lower front headlamp
5.9 Nm (4.4 lbs-ft)
  • Torx T30 socket
  • Flex head ratchet/flex head torque wrench
  • 2 in extension
Reuse
Bolt that attaches the LH front fascia center bracket to the vehicle
5 Nm (3.7 lbs-ft)
  • Torx T25 socket
  • Flex head ratchet/flex head torque wrench
Replace with black bolt (1551442-00-A)

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Remove and discard the bolt that attaches the LH front fascia center bracket to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench
  3. Remove the bolt that attaches the LH headlight to the fender, and then lower the front headlight.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  4. Maneuver the LH front fascia center bracket rearward to remove it from the vehicle.

Install

  1. Install the LH front fascia center bracket.
  2. Position the headlamp, and then install the bolt that attaches the headlamp to the fender.
    5.9 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  3. Install a new bolt that attaches the LH front fascia center bracket to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Install a new black bolt (1551442-00-A).
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench
  4. Install the front fascia. See Fascia - Front (Remove and Install).