2023-12-15
Clevis Pin - Brake (Remove and Replace)
Correction code
33253102
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Remove the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Replace).
- Move the LH front seat backward.
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Remove the brake light switch. See Switch - Brake Light (Remove and Replace).
- Remove the brake clevis pin cotter pin.
- Remove the clevis pin from the brake pedal assembly.
Install
- Align the brake pedal to iBooster rod and install the clevis pin to the brake pedal assembly.
- Install the brake clevis pin cotter pin.
- Install the brake light switch. See Switch - Brake Light (Remove and Replace).
- Connect 12V power. See 12V/LV Power (Disconnect and Connect).
- Install the HEPA filter assembly. See Assembly - Filter - HEPA (Remove and Replace).
- Move the LH front seat to the original position.
- Raise the LH front window and close the LH front door.