Sensor - Pressure - Door - Front - LH (Remove and Replace)
     Correction code
    
                           20200102
                           
                           0.36
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
    Correction code
    
                           20200102
                           
                           0.36
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
    
    
    
  
Remove
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Remove the front LH door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
- 
          Disconnect the electrical connector from the front door airbag sensor.
          
- 
          Twist the tabs counterclockwise and remove the front door airbag sensor from the closeout panel.
          
Install
Installation procedure is the reverse of removal.