11/05/2023 19:42:08

Back Panel – 2nd Row Seat – Center/20 (7-Seat) (Remove and Replace)

Correction code 13082332 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Move the LH 2nd row seat back forward.
  3. Release the center 2nd row seat switch, disconnect the switch connector, and then remove the switch from the seat assembly.
    Tip: Use a plastic trim tool pry the top of the switch away from center seat back panel.
  4. Release the clips (x5) that attach the center 2nd row seat back panel to the center seat assembly, slide the panel forward to release the hooks (x2), and then remove the panel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Early production vehicles may have 4 hooks.

Install

  1. Insert the center 2nd row seat back panel hooks (x2) into the center seat back assembly, and then slide the panel rearward into position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Early production vehicles may have 4 hooks.
  2. Secure the clips (x5) that attach the center 2nd row seat back panel to the center seat back assembly.
  3. Position the center 2nd row seat switch into the vehicle, connect the switch connector, and then install the switch into the seat assembly.
  4. Move the LH 2nd row seat back into the original position.
  5. Raise the LH rear window and close the LH front door.