2026-07-17

LED Light - Center Console (Remove and Replace)

Correction code 1519020302 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-07-17: Released new procedure.

Torque Specifications

Table 1. Torque Specifications: Center Console (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Center console side and rear corner to body bolts
7 Nm (5.2 lbs-ft)
  • 10 mm socket
Reuse
Inner front center console to body screws
1.7 Nm (1.3 lbs-ft)
  • Torx T20 socket
  • Wiha TorqueVario-S 0.8 Nm - 2.0 Nm screwdriver (installation only)
Reuse

Remove

  1. Remove the center console from the vehicle. See Center Console (Remove and Install).
  2. Release the tabs (x2), then disconnect the center console LED connector.
  3. Release the clips (x2), then remove the LED light from the center console.

Replace

  1. Secure the clips (x2) that attach the LED light to the center console.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the clips are fully seated.
  2. Route the center console LED light connector through the tabs (x2).
  3. Install the center console onto the vehicle. See Center Console (Remove and Install).