Sensor - Radar - Front (Remove and Replace)
Correction code
17201502
1.38
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the front fascia. See Fascia - Front (Remove and Install).
-
Disconnect the electrical
harness connector from the radar sensor.
-
Release the holding tab that attaches the radar sensor to the front
radar sensor bracket, and then remove the sensor from the vehicle.
Install
-
Install the front radar sensor into the bracket.
-
Connect the front radar sensor electrical connector.
- Install the front fascia. See Fascia - Front (Remove and Install).
- Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
- Perform the front radar sensor calibration procedure. See Sensor - Radar - Front (Calibration).