24/03/2020 17:59:54

Filler Neck - Reservoir - Windshield Washer (LHD) (Remove and Replace)

Correction code 17503002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Use a clip prytool to release the push clip that attaches the windshield washer reservoir filler neck.
  3. Release the washer hose from the retaining tabs (x3).
  4. Pull the filler neck directly away from the windshield washer reservoir to remove it.
    Informational PurposesAn informational icon, calling your attention
    Note
    The filler neck is equipped with an O-ring.

Install

Installation procedure is the reverse of removal, except for the following:

  • Ensure the new filler neck is equipped with an O-ring. If an O-ring is not installed, install one.