Latch - Liftgate (Remove and Replace)
Correction code
11355002
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts that attach the liftgate latch to the liftgate |
![]() 10 Nm (7.4 lbs-ft) |
|
Reuse |
Remove
- Remove the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Disconnect the electrical connector from the latch.
-
Remove the bolts that attach the latch to the liftgate lid, and then remove the latch from the vehicle.
NoteThe latch has tabs on the backside. Slide the latch upwards to release the tabs from the liftgate.NoteUse of the following tool(s) is recommended:
Install
-
Install the bolts that attach the latch to the liftgate lid.10 Nm (7.4 lbs-ft)NoteThe latch has tabs on the backside. Position the latch so that the tabs enter the locating holes in the liftgate.NoteUse of the following tool(s) is recommended:
- Connect the electrical connector to the latch.
- Install the liftgate lower trim. See Trim - Liftgate - Lower (Remove and Replace).
- Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
- Close the liftgate.