Bump Stop - Liftgate - LH (Remove and Replace)
Correction code
11335202
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2024-06-04: Added link to Toolbox article for additional information on bump stop adjustment.
Remove
Install
Installation procedure is the reverse of removal, except for the following:
- Install the bump stop using the same number of turns as noted during removal.
- Verify the flushness from the
liftgate to the rear fascia assembly, and adjust as necessary.NoteRefer to Toolbox article 8199800 for additional information on bump stop adjustment.