24/07/2023 17:17:07
Module - ECU - Occupant Classification System (OCS) - Front Passenger (Remove and Replace)
Correction code 13010012 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
Seat base edges are
sharp and can cause personal injury. Wear cut resistant gloves when removing the seat
from the vehicle, and while performing procedures that involve work on or near the seat
base.
Remove
- Check that the firmware is version 2023.2.11 or above. If the firmware version is not 2023.2.11 or above, update the vehicle firmware.
- Open the RH front door and lower the RH front window.
- Move the front passenger seat forward and raise the seat to the highest position.
-
Disconnect the self capacitance trace
connector from the OCS ECU module.
-
Disconnect the RH front seat harness
connector from the OCS ECU module.
-
Release the tabs (x2) that attach the
front passenger OCS ECU module to the seat assembly, and then remove the module from the
vehicle.
Install
-
Position the front passenger OCS ECU
module to the vehicle, and then secure the tabs (x2) that attach the module to the seat
assembly.
-
Connect the RH front seat harness connector to the OCS ECU module.
-
Connect the self capacitance trace connector to the OCS ECU module.
- Move the front passenger seat to the original position.
- Raise the RH front window and close the RH front door.
-
If servicing the front passenger seat in
a North American vehicle:
- Remove all objects from the front passenger seat before beginning calibration.
- On the vehicle touchscreen, touch Software Reinstall - Touchscreen. If the vehicle firmware is not 2023.2.11 or newer, update the vehicle firmware. See Software Update. and check the vehicle firmware version. If the vehicle firmware is 2023.2.11 or newer, perform a software reinstall. See
- Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
- Unlock the vehicle gateway. See Gateway (Unlock).
- In Toolbox, click on the Actions tab, and then search for "OCS".
- Run the PROC_OCS1P_SELF-CALIBRATIONSearch for routine in ToolboxSafety & Restraints / Seats - OCS1P Self Capacitance Calibration routine.
- Click on the Actions tab, and then search for "Seat calibration".
- Run the PROC_VCRIGHT_SEAT-CALIBRATESearch for routine in Toolbox routine.
- Disconnect Toolbox and remove the laptop from the vehicle.