09/04/2021 08:57:03

Side Shield Sub-Assembly - 2nd Row Seat (7-Seat) (Remove and Replace)

Correction code 13080052 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the RH doors and fully lower the RH windows.
  2. Move the passenger seat fully forward.
  3. Move the RH 2nd row seat to easy entry mode.
  4. Remove the RH 2nd row seat toe kick cover. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  5. Remove the clip that attaches the RH 2nd row seat side shield to the cushion pan.
  6. Release the clip that attaches the RH 2nd row seat side shield to the RH 2nd row seat assembly, and then lift the shield up to release it from the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not pull the shield away from the assembly as there is still an electrical connector connected.
  7. Disconnect the RH 2nd row seat side shield electrical connector, and then remove the shield from the assembly.

Install

  1. Connect the RH 2nd row seat side shield electrical connector.
  2. Position the RH 2nd row seat side shield onto the RH 2nd row seat assembly, and then install the clip.
  3. Install the clip that attaches the RH 2nd row seat side shield to the cushion pan.
  4. Install the RH 2nd row seat toe kick cover. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  5. Move the RH 2nd row seat to its original position.
  6. Move the passenger to its original position.
  7. Close the RH doors and raise the RH windows.