2021-12-08

Foam - Bumper Beam - Front (Remove and Replace)

Correction code 10011702 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Remove the front bumper beam foam from the front bumper beam.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the vehicle is equipped with pedestrian protection systems, disconnect and remove the pressure tube sensors from the front bumper beam foam.

Install

  1. If the vehicle is equipped with pedestrian protection systems, install the pressure tube sensor on the new front bumper beam foam.
  2. Install the front bumper beam foam onto the front bumper beam.
  3. Install the front fascia. See Fascia - Front (Remove and Install).