2025-03-10
Camera - Rear Facing (Remove and Replace)
Correction code 17250102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Procedure
Warning
Whenever a camera has been moved out
of its original position (for example, a camera or windshield replacement), camera
calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration >
Clear
Calibration.
- The rear facing camera cannot be ordered as a separate part. If a replacement is needed, replace the liftgate exterior release switch and the rear facing camera assembly. See Switch and Camera Assembly - Exterior Release - Liftgate (Remove and Replace).