29/05/2024 18:10:58

Center Console (Remove and Replace)

Correction code 15190102 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the security body controller to the cup holder decor panel
1.6 Nm (1.2 lbs-ft)
  • Torx T20 socket
Reuse
Screws (x4) that attach the center console bright strip to the center console assembly
1.6 Nm (1.2 lbs-ft)
  • Torx T20 socket
Reuse

Remove

Informational PurposesAn informational icon, calling your attention
Note
The security controller currently on the vehicle will be transferred to the replacement center console. This will allow the vehicle/keys to function without the need for reconfiguration.
  1. Remove the center console assembly. See Center Console (Remove and Install).
  2. Release the clips (x4) that attach the rear of the LH decor trim to the center console assembly
  3. Remove the screws (x4) that attach the rear of LH center console bright strip to the center console assembly.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Release the tabs (x3) that attach the rear of the LH center console bright strip to the center console assembly, and then partially release the bright strip from the assembly.
  5. Repeat the step 2 through step 4 for the RH side of the center console.
  6. Release the clips (x6) that attach the cup holder decor panel to the cup holder assembly, and then separate the cup holder decor panel from the center console assembly.
  7. Disconnect the electrical connector from the security body controller module, and then remove the cup holder decor panel from the vehicle.
  8. Remove the screws (x2) that attach the security body controller module to the cup holder decor panel, and then remove the security body controller module from the panel.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  9. Repeat step 2 through step 7 for the new center console assembly.

Install

  1. Position the security controller onto the new cup holder decor panel, and then install the screws that attach the controller to the panel.
    1.6 Nm (1.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Connect the electrical connector to the security body controller module.
  3. Attach the clips (x6) that attach the cup holder decor panel to the center console assembly.
  4. Install the RH center console bright strip to the center console assembly.
  5. Install the screws (x4) that attach the RH center console bright strip to the center console assembly.
    1.6 Nm (1.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  6. Install the RH decor trim onto the center console assembly
  7. Repeat step 4 through step 6 for the LH side of the center console.
  8. Install the center console assembly. See Center Console (Remove and Install).