01/12/2021 11:50:18

Coat Hook - Rear - LH (Remove and Replace)

Correction code 15204302 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Coat Hook - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the LH coat hook assembly to the rear headliner
1 Nm (.7 lbs-ft)
  • Torx T20 socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Lower the rear headliner. See Headliner - Rear (Remove and Replace).
  2. Release the tabs that attach the coat hook to the headliner, and then gently pry the coat hook from the headliner.
  3. Release the electrical harness from the rear portion of the headliner, and then disconnect the electrical harness from the LH rear map light connector.
  4. Remove the screw that attaches the LH coat hook tether to the roof clip.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Wiha TorqueVario-S 0.8 Nm - 2.0 Nm screwdriver (installation only)
    • Wiha ¼ in bit holder adapter
  5. Remove the screws that attach the LH coat hook assembly to the rear headliner, and then remove the assembly from the vehicle.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Flex head ratchet/flex head torque wrench
  6. Remove the LH coat hook roof clip from the body.

Install

Installation procedure is the reverse of removal.