Light - Turn Signal / Fog - Front - LH (Remove and Replace)
Correction code 17404002 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the LH front turn signal/fog light to the front fascia |
|
|
Reuse |
Remove
- Remove the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the LH front fender garnish. See Garnish - Fender - Front - LH (Remove and Replace)
- Release the clips (x9) that attach the front portion of the LH front wheel arch liner to the vehicle, and then move the liner aside to perform the following steps.
- Pull the red tab away from the electrical connector to release the connector lock, and then disconnect the electrical connector from the LH front turn signal/fog light.
- Release the clips that attach the fascia electrical harness to the LH front turn signal/fog light.
-
Remove the screws, and then
release the tabs that attach the LH front turn signal/fog light to the front
fascia.NoteUse of the following tool(s) is recommended:
- Torx T25 socket
- 4 in extension
- Remove the LH front turn signal/fog light from the vehicle.
Install
Installation procedure is the reverse of removal.
After reinstalling all components, adjust the front fog lights to specification. See Light - Fog - Front (Adjust).