07/05/2020 17:01:26

Cover - Tow Hook - Rear (Remove and Install)

Correction code 10012011 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Place two thumbs at the 1 and 2 o'clock positions, resting your knuckles on the bumper fascia surface to support your hand position. Use both thumbs to apply force on the outer edge of the cover.

Install

  1. Insert location tab between the 1 and 2 o'clock position and rotate the bottom snap fit tabs into the slots in the fascia. Once the tabs are located, push on the outer edge to snap the cover on.